Maintenance And Cleaning - Di4 Vapore Stiro Healthy 3200 Manual De Instrucciones

MAINTENANCE AND CLEANING

It is recommended to the self-cleaning every two weeks if the water in the area is hard or semi-hard if
frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled
down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.
Cleaning the soleplate; Do not use scouring pads or harsh cleaners on the soleplate as these will dam-
age the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the sole-
plate, simply wipe with soft damp cloth and wipe dry.
SELF-CLEANING
After a period of use, the automatic clean warning lamp "calc" flashes, indicating that the self-clean
process must be performed.
1. Fill the water reservoir to the level mark for maximum filling.
2. Insert the main plug into the wall socket.
3. Set the temperature control to its maximum position.
4. Allow the iron to heat up until the indicator light becomes fixed and two beeps will be heard. Unplug
the iron (very important!)
5. Holding the iron horizontally over the sink, press the button of "clean".
Shake the iron back and forth keeping it in a horizontal position. Boiling water and steam will be ejected
from the holes in soleplate with impurities washed out.
6. When the iron stops dripping, release the button. Check carefully that the water tank is empty (very
important!).
7. Plug the iron in and heat it up again until the remaining water has evaporated.
8. Press the "SET" button for three seconds or until the "calc" lamp goes off.
9. Unplug the iron and let the soleplate cool down. Move the iron over an old (preferably) piece of cloth.
This ensures that the soleplate will be dry during storage.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing.
Please note:
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the
above-mentioned regulations leads to the loss of guarantee.
SELF CLEAN FILTER
The "self-clean" filter prevents motor from blocking.
SENSE TECHNOLOGY
The iron handle incorporates a sensor that, when the variable steam is selected, will turn on the variable
24