Ingeteam NEO Manual De Usuario página 15

Charger management from the INGETEAM NEO App
Location of the measuring device
2
Home
circuit
General
circuit
3 Contracted power
Select Contracted power, i.e. what is available in your home. This should never be exceeded
by the combined consumption of the home and the electric vehicle. CURVEx3
Communications Select the mode that the charger will use to connect to the internet and allow remote
communication in real time with the INGETEAM NEO App:
Only in NEO Pro
chargers.
WI-FI: Press the Connect button and follow the steps below:
The INGETEAM NEO App will query the charger about the WI-FI networks that are
1
visible for the unit. To do this, the App will show a window with the message Device
to use with WF_XXXXXXXX. Here, press the CONNECT button.
Next, the INGETEAM NEO App will show the list of visible WI-FI networks, their
2
signal level and their protection. Select the WI-FI network that you want the charger
to connect to. If it is protected, enter your password in the window that will open
next and press CONNECT.
The INGETEAM NEO App will automatically perform the actions required for
3
connecting to the selected WI-FI network. Once the process is completed, press
Finalize.
Local Network: Slide the selector and, if the charger is on a local network, a few seconds
later the screen will display the IP address that has been assigned to the charger.
Mobile data (optional): Slide the selector, complete the necessary data for the connection
to the mobile network (Access point, Username, Password and SIM card PIN) and press
Confirm.
Restart Pressing the Restart button will make the charger turn off, turn on again, and launch its
operating system again, but without losing the configuration it had up to that moment.
This feature should not be used unless the charger is locked and is not responding to user
commands and actions. In case of doubt, see the User Support Service in the CONTACT
section of the App.
ABV2014IQM01_ - User Manual
Select Home circuit when the measuring device is located in a circuit that
only measures the consumption of the home, but not the consumption of the
charger.
Select General circuit when the measuring device is located in a circuit that
measures the entire consumption, including home and charger.
Ingeteam
EN
ES
FR
IT
15