Long-Term Storage; Technical Assistance; Assembly Instructions; Wheels - Vito Agro VIMEDTD12A Manual De Instrucciones

Use only VITO-approved attachable accessories for this
diesel tiller or technically identical parts. Failure to do
so may result in personal injuries or damages to the
diesel tiller. If necessary, they should be replaced by an
official distributor.
For safety reasons, the fuel system components (hose,
tap, tank, tank cap and couplings) should be inspected
regularly regarding damage and leaks. If necessary, they
should be replaced by an official distributor.
Always keep warning and information stickers clean and
legible.
Keep all nuts, pins and bolts well tightened in order to
ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately.
When replacing the tines, pay attention to the type of
tines and if they match. Only use VITO-authorized tines.

Long-term storage

Allow the combustion engine to cool down before
putting the appliance in a closed compartment.
Never store the tiller with diesel in the tank inside a
building. Diesel vapors may come into contact with
flames or sparks and ignite.
Store the diesel tiller in a dry area, with the fuel tank
empty in a well-ventilated location.
If you want to empty the tank, for example before the
winter period, the fuel tank should only be emptied
outdoors.
Clean the machine thoroughly before storage,
especially on winter. Store the tiller in a good operating
condition.
Ensure that the diesel tiller is protected against misuse
(e.g., by children).

Technical Assistance

The diesel tiller should only be serviced by the brand's
technical assistance center, or other qualified
personnel, replacing any necessary parts with original
parts.

ASSEMBLY INSTRUCTIONS

Before start assembling, note the safety
instructions.
Carry out all assembly work on a horizontal, firm and
clean surface. Respect the assembly positions and
always ensure a stable and safe position of the
appliance.
Wear close-fitting gloves when touching the tines.

Wheels

Drive wheels
1. Align the drive shaft;
2. Tighten the hex bolts to secure the drive shaft;
3. Mount the shafts on both wheels;
4. Fit the wheel shaft to the drive shaft;
5. Insert the clevis pins in the drive wheel shafts holes
and the drive shaft holes. Insert the R-clip.
Pay attention to the direction of rotation of the
wheels.

Front stand

1. When stopping or storing the tiller, you must place
the stand (1) vertically to keep the appliance
balanced;
2. When operating or transporting the tiller, the front
stand must be lifted up.

Handlebar

1. Fit the handlebar crown gear to the handlebar base
and adjust according to the desired height;
2. Tighten the handlebar fixing lever (15);
3. Adjust and attach the clutch, throttle, reverse and
safety lever cables with the cable ties provided.
43