Operating The Tiller In Reverse; Gear Shift Lever; Throttle Lever; Stopping The Engine - Vito Agro VIMEDTD12A Manual De Instrucciones

Operating the tiller in reverse

1. Press the reverse gear lock and the reverse gear
handle simultaneously;
2. Press the safety clutch lock lever (13) and squeeze
the clutch lever (12).
3. When the clutch lever is squeezed, the gearbox
engages the drive shaft;
4. When you release the clutch lever the drive shaft
stops;
When reversing, keep the safety distance and
hold the handlebar firmly so as to avoid stumbling
and the machine passing over you.

Gear shift lever

1. The gear shift lever (9) must be handled when the
clutch handle is released;
2. The gear shift lever allows you to select three
positions according to the desired operating mode: 0,
1 and 2;
3. After setting the speed, squeeze the clutch lever (12)
and the drive shaft starts spinning.
Start-up movement can be quite abrupt. Hold the
handlebar firmly.

Throttle lever

The throttle lever (10) allows you to adjust the rotation
speed of the combustion engine.
Turn the lever to the desired speed. On the right, it is in
the stop position; on the left it is at full speed.

Stopping the engine

In normal operation
1. Release the clutch handle (12), and set the gear shift
lever (9) to neutral position (0);
2. Set the throttle lever (10) to the left;
3. Turn the ignition key to the "OFF" position;
4. Close the fuel valve, set it to an upright position.
In case of an emergency
To stop the engine, turn the ignition key to the "OFF"
position.
46

Fuel

The engine runs on diesel. Never use contaminated
diesel or other type of fuel. Avoid dirt or water in the
fuel tank. Otherwise, problems may arise with the fuel
pump and injectors.
To check the fuel level and fill the tank, the engine must
be stopped. When refueling the tank, do not exceed the
maximum level, the upper limit of the filter.

MAINTENANCE INSTRUCTIONS

Checking and changing the engine oil

An engine running with low oil level will cause
severe engine damage.
1. Place the tiller on a firm and level surface;
2. Remove the oil filler cap (cap + dipstick) (18);
3. Check oil level;
4. If the level is low, add oil (15W40) until the
appropriate level is reached.
To change the oil:
5. Remove the fender guard (17);
6. Remove the oil drain plug and empty all the oil;
7. Tighten the oil drain plug and add new oil;
8. Check the oil level and adjust to the correct level.

Checking and changing the gearbox oil

1. Place the tiller on a firm and level surface;
2. The gearbox oil must be leveled with the lower limit
of the gearbox oil cap.
3. If the level is low, add oil (80W90) until the proper
level is reached;

Air filter cleaning

1. Loosen the spring clips, remove the bottom filter
cover (4) and the filter element;
2. Dispose of the old oil in the cover and blow the filter
element out with compressed air until it is
completely clean;
3. Loosen the spring clips, remove the side filter cover
and the filter element;
4. Blow the filter element out with compressed air until
it is completely clean;
5. Add new oil (15W40) until the O-ring on the bottom
cover is covered;
6. Install all filter elements in the filter and assemble the
remaining components
disassembly.
in reverse order to