Tool Box; Air Filter; Gear Shift Lever; Battery - Vito Agro VIMEDTD12A Manual De Instrucciones

Tool box

1. Align the tool box (14) into the handlebar hole;
2. Insert the bolt and tighten the locknuts.

Air filter

1. Remove the nuts and adjust the rubber gasket;
2. Fit the air filter (4) to the fixing bolts, fit the washers
and tighten the nuts.

Gear shift lever

1. Adjust the handlebar fixing bar with the handlebar
bracket. Insert the R-clip;
2. Adjust the lever hole with the drive engagement
cable. Insert the clevis pin and R-clip;

Battery

1. Place the battery (6) in the bracket with the terminals
facing the handlebar;
2. Place the fixing bar on the opposite edge of the
terminals;
3. Insert the threaded rod into the holes of the bracket
and the fixing bar;
4. Tighten the nuts.

Connecting the battery

1. Connect the cables to the terminals;
2. They must be connected according to their polarity:
- Red cable to the positive terminal;
-Black cable to the negative terminal (-);
3. Tighten the bolts.
4. Connect the other end of negative cable (-) to
ground;
5. Connect the other end of the positive cable (+) to the
ignition coil.
44

Automatic start-stop system

1. Remove the key from the ignition switch;
2. Remove the nut and lock washer;
3. Insert the switch into the support base;
4. Place the washer and secure the nut;
5. Clamp the wire-to-wire connectors.

Fender guard

1. Place the rear support bar on the farming tools
holder. Tighten the bolts with the respective nuts and
washers.
2. Place the side support bar next to the engine and
gearbox. Insert the bolts from the bottom upwards;
3. Adjust the inner fender guard according to the holes
in the holders. Insert the bolt and tighten the lock
nuts;
4. Adjust the outer fender guard to the inner one to
match the holes. Insert the bolts and tighten the lock
nuts.

Front grille guard

1. Align the bracket's holes with the engine' holes.
Insert 1 bolt from bottom to top in each hole. Place
washers and tighten with a nut;
2. Proceed in the same way for the other bracket;
3. Align brackets' holes with the front grille guard. The
brackets should be on the outside. Insert 2 bolts in
each bracket and tighten them.
The brackets allow you to adjust the grille further
forwards or backwards as desired.