Installation - universalblue ube2407-21 Manual De Instrucciones

5. INSTALLATION

The following instructions are directed at the qualified installers, so
the installation and maintenance procedures should be followed as
professionally as possible.
Unplug the hob from the power source before performing
any maintenance, installation or repair procedures.
POSITIONING THE GAS HOB
This unit should be installed and used only in adequate
ventilated spaces.
Please follow the steps below:
 The place where the hob is to be installed must be suitable,
with a ventilation system that allows fumes and gases to be
vented to the outside. A ventilation hood or an electric fan that
activates automatically when the hood is in use should be
installed.
 The room must also allow the necessary entry of air for proper
combustion. The airflow for combustion purposes should not
be less than 2 m³/h per kW of installed capacity. The air supply
can be made through a direct entry from the outside through a
conduit with an internal cross section of at least 125 cm2,
36