Thermostat Installation - Emos P5606OT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 132
18 – Chosen programme
19 – Holiday mode symbol
20 – Lock display
21 – Temporary mode symbol
22 – Automatic mode (AUTO) symbol
23 – Manual mode (MAN) symbol
24 – Low battery
INSTALLATION
Warning:
Before changing the thermostat, disconnect the heating/air-conditioning
system from the main power in your flat. This will prevent potential injury
by electric current.
Thermostat Placement
Thermostat location significantly affects its functioning. Choose a room
where members of the family spend most of their time, preferably on the
inside wall where air circulates freely, with no direct sunlight. Do not place
the thermostat in the vicinity of heat sources (such as TV sets, radiators,
fridges), or close to a door (due to frequent shocks or vibration). If you do
not comply with these recommendations, the thermostat will not control
room temperature correctly.

Thermostat Installation

1. Remove the rear cover of the switching unit.
2. Mark positions for holes.
3. Drill two holes, carefully insert the plastic wall plugs into them and
use two screws to fasten the rear switching unit cover.
4. Connect the wires to the labelled terminals according to the wiring
diagram.
5. Complete the installation by fitting the switching unit onto the
attached rear part of the cover.
Wiring Diagram
ON/OFF connection
NO
normally open contact
COM switch contact
NC
normally closed contact
4

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido