Emos P5606OT Manual De Instrucciones página 6

3. After choosing a mode, press the
on the display and the time value will start flashing. Use + or - to
set time to a value of choice.
4. Once time is set, press the
will start flashing. Use + or - to set the temperature.
5. Once temperature is set, press the
on the display and the time value will start flashing. Repeat steps 3
and 4 until all six programmes are set.
6. After setting all six programmes to the values of choice, press the
button to confirm or wait 60 seconds for automatic confirmation.
Using the Copy Function
The thermostat is equipped with a copy function which allows copying an
edited programme to another day. You therefore do not have to repeatedly
enter the same programme for the next day. This function only works
when programming individual days.
1. First, set and save a programme for at least one day; see Pro-
gramme Settings.
2. If the thermostat is set to day mode and the slider is on PROG,
press the C button.
3. „MO" will appear on the display; at this point, use + or - to select
which day's settings you wish to copy to another day.
4. Press the button; „TU" will start flashing on the display. Use +
or - to choose the day you wish to copy the selected settings into.
5. Press the C button to confirm your day selection; „SAVE" will appear
on the display. To choose additional days, repeat steps 3 and 4.
6. After copying the original setting to the days of choice, confirm by
pressing the button or wait 60 seconds for automatic confirmation.
Temporary Mode
1. Move the slider to AUTO.
2. Use + or - to set the temperature of choice; a hand icon will appear
on the display.
3. Press the button to confirm or wait 15 seconds for automatic
confirmation.
This temperature setting will apply until the next preset programme
begins or until you press the
Manual Temperature Setting Mode (MAN)
1. Move the slider to MAN.
2. Press + or - to adjust temperature.
In this mode, the thermostat always maintains the manually set temper-
ature and preset programmes are not active. You can cancel the mode
by moving the slider to another position.
button once; „P1" will appear
button once; the temperature value
button once; „P2" will appear
button again to cancel temporary mode.
6