10.2 Adjust The Chain Tension - GreenWorks CSF404 Manual Del Operador

EN
3. Put the chain drive links (21) into the bar groove
(20).
4. Put the chain cutters (22) in the direction of the
chain operation.
5. Ensure the chain is put on in the correct direction
(do not assemble with the cutters backwards).
6. Put the chain in position and make sure that the
loop is behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket (16).
9. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt (17).
English
10. Install the chain cover.
11. Tighten the chain. Refer to Adjust the chain tension.
12. Tighten the nuts when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after the
first use, examine the tension and tighten the chain if
necessary.

10.2 ADJUST THE CHAIN TENSION

The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take
up the slack.
Tension the chain so that it can only just be pulled away
from the bar at its centre point.
A slack chain may jump off and cause serious or even
fatal injury.
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1. Stop the machine.
2. Loosen the lock nuts with the wrench.
It is not necessary to remove the chain cover to adjust
the chain tension.
3. Turn the chain adjustment screw clockwise to
increase the chain tension.
12
NOTE
WARNING
CAUTION
NOTE