Cleaning The Electrobrush; Replacing The Rechargeable Battery - Miele Triflex HX1 Instrucciones De Manejo

en
 Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it (Fig. 30).
 Clean the dust container using water
and mild washing-up liquid.
 Dry the dust container thoroughly.
 Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Fig. 32 + 33).
 Reattach the dust container to the
PowerUnit connector.
Cleaning the Electrobrush (Fig. 34)
 Disconnect the Electrobrush from the
vacuum cleaner (Fig. 10).
 Place the Electrobrush upside down
on a level, clean surface.
 Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors. To guide
the scissors, move along the guide
track on the roller brush.
Then run the vacuum cleaner to va-
cuum up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning. To re-
move them, use a flat-head screw-
driver.
Removing the roller brush from the
Electrobrush (Fig. 35)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
80
 Unlock the cover on the side of the
Electrobrush so that the  symbol
becomes visible a.
 Lift the cover up as far as it will go b.
 Remove the roller brush c.
 Remove the roller brush handle if you
identify heavy soiling there d.
 Clean the roller brush and the roller
brush handle, and remove any stub-
born soiling inside the Electrobrush.
 Reassemble the Electrobrush in re-
verse order.

Replacing the rechargeable battery

An original Miele AP01/AP02/AP03 lith-
ium-ion rechargeable battery (HX LA) is
required.
Follow the instructions regarding the
handling and disposal of rechargeable
batteries found in the following sec-
tions: "Warning and safety", "Caring
for the environment" and "Installation
and connection - General battery in-
formation").