To Examine The Battery And The Battery Charger; To Clean The Product, The Battery And The Battery Charger; To Lubricate The Shaft - Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario

Maintenance
Lubricate the shafts.
Apply dielectric grease to the shaft
coupling.
Do a check of the connections be-
tween the battery and the product.
Do a check of the connection be-
tween the battery and the battery
charger.
Do an inspection of the dielectric
shaft for worn and damaged areas.
Do not use the product if the die-
lectric shaft has worn or damaged
areas. Refer to OSHA 1910.269 for
more information.
Make sure that the saw head is not
damaged. Replace the saw head if it
is damaged.
Examine the wear of the chain drive
sprocket.
To examine the battery and the
battery charger
1. Examine the battery for damages, for
example cracks.
2. Examine the battery charger for damages,
for example cracks.
3. Make sure that the connection cord of the
battery charger is not damaged and that
there are no cracks in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after
use.
2. Clean the battery and battery charger with
a dry cloth. Keep the battery guide tracks
clean.
3. Make sure that the terminals on the battery
and the battery charger are clean before
the battery is put in the battery charger or
the product.

To lubricate the shaft

Lubricate the ends of the drive shaft after
each 30 hours of operation. There is a risk
that the ends of the drive shaft (splined
1824 - 004 -
Daily
X
An approved Husqvarna dealer must do all servicing on
Replace the chain drive sprocket after approximately
100 hours of operation or more frequently if it is neces-
coupling) wears if they are not lubricated
regularly.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
2. Lubricate the end of the drive shaft.
3. Assemble the shaft. Refer to
the shaft on page 14 .
To apply dielectric grease to the
shaft coupling
Apply dielectric grease to the inner surface of
the shaft coupling and the outer surface of the
shaft after each 30 hours of operation.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
Weekly
X
X
the saw head.
sary.
Monthly
X
To
To assemble
To
21