To Assemble The Impact Guard - Husqvarna 525P4S Manual De Usuario

To assemble the two-piece shaft
525P5S
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
703 - 008 - 02.11.2022
To disassemble the two-piece shaft
525P5S
1. Turn the knob 3 turns or more to loosen the
A
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the engine is
4. Pull the attachment straight out of the coupling.

To assemble the impact guard

1. Assemble the guard with 3 screws.
2. Tighten the screws to 30 ft/lbs (4 Nm).
3. Tighten the screws again when the product has been
coupling.
attached to.
C
in use for about 20 hours.
11