Parkside PWDS 920 B2 Instrucciones De Utilización Y De Seguridad página 81

7) Do not use a damaged accessory.
Before each use inspect the
accessory such as abrasive wheels
for chips and cracks, backing pad
for cracks, tear or excess wear,
wire brush for loose or cracked
wires. If power tool or accessory
is dropped, inspect for damage or
install an undamaged accessory.
After inspecting and installing an
accessory, position yourself and
bystanders away from the plane of
the rotating accessory and run the
power tool at maximum no-load
speed for one minute. Damaged
accessories will normally break apart during
this test time .
8) Wear personal protective
equipment. Depending on
application, use face shield, safety
goggles or safety glasses. As
appropriate, wear dust mask,
hearing protectors, gloves
and workshop apron capable
of stopping small abrasive or
workpiece fragments. The eye
protection must be capable of stopping flying
debris generated by various operations .
The dust mask or respirator must be capable
of filtrating particles generated by your
operation . Prolonged exposure to high
intensity noise may cause hearing loss .
9) Keep bystanders a safe distance
away from work area. Anyone
entering the work area must
wear personal protective
equipment. Fragments of workpiece or of
a broken accessory may fly away and cause
injury beyond immediate area of operation .
10) Position the cord clear of the
spinning accessory. If you lose control,
the cord may be cut or snagged and your
hand or arm may be pulled into the spinning
accessory .
11) Never lay the power tool down
until the accessory has come to a
complete stop. The spinning accessory
may grab the surface and pull the power
tool out of your control .
12) Do not run the power tool while
carrying it at your side. Accidental
contact with the spinning accessory could
snag your clothing, pulling the accessory into
your body .
13) Regularly clean the power tool's
air vents. The motor's fan will draw
the dust inside the housing and excessive
accumulation of powdered metal may cause
electrical hazards .
14) Do not operate the power tool near
flammable materials. Sparks could
ignite these materials .
GB/MT 79