Teaching Your Pet To Use The Feeder; Cleaning & Maintenance - SURE petcare SureFeed Microchip Pet Feeder Guia De Inicio Rapido

safety collar which incorporates a breakaway buckle. Sure Petcare cannot accept liability for any injury or
death caused by a pet's collar.
C
ustom software settings are available from customer support to alleviate most unwanted pet behaviour.
Before Installation or using the product please download and read the user instructions, these are
available from surepetcare.com/pdf.

Teaching your pet to use the feeder

It is important to allow your pet to get used to their new feeder for a couple of
days without any lid movement. With the lid closed press the Training Function
button ( ) once on the rear of the feeder. The lid will open and the light will flash
orange (once every few seconds).
Now start to add increasing amounts of movement to the lid. This allows your pet to get used to the
motion of the lid in 3 stages.
Do not proceed to the next step until your pet is confident with the motion.
1
Press the ( ) button. The lid
will close a small amount and
the light will flash orange twice.
Once your pet is happy with this final position, press ( ) again. The lid will close fully and the light
will no longer flash.The feeder is now sealed and in daily use mode.
Cleaning & maintenance
It is important to keep your SureFeed Microchip Pet Feeder clean to ensure it functions reliably.
Do not put the whole feeder into water or the dishwasher.
The feeder should be wiped with a damp cloth or household cleaning wipes.
How to remove the lid for cleaning:
1
Move the slider to the
unlocked position and press
the ( ) button on the back.
3
2
Press the ( ) button again.
The lid will close to the next
position and the light will flash
orange 3 times
2
Turn the feeder so the back is
facing you and pull the lid up.
(training mode)
3
Press the ( ) button again. The
lid will close to its final position
and the light will flash orange
4 times
3
Hand wash the lid. Do not put it
in the dishwasher.