Warranty & Disclaimer - SURE petcare SureFeed Microchip Pet Feeder Guia De Inicio Rapido

Warranty & disclaimer
Warranty: The SureFeed Microchip Pet Feeder carries a 3-year warranty from the date of purchase, subject to
proof of purchase date. The warranty is restricted to any fault caused by defective materials, components or
manufacture. This warranty does not apply to products whose defect has been caused by normal wear and tear,
misuse, neglect or intentional damage. In the event of a part failure due to faulty parts or workmanship, the part
will be replaced free of charge during the warranty period only. At the manufacturer's discretion, a replacement
product may be provided free of charge in the case of a more serious malfunction. Your statutory rights
are not affected.
Disclaimer: The SureFeed Microchip Pet Feeder incorporates selective access features which have been designed
to minimise the risk of pets eating each others' food. However, it is not possible to fully guarantee the exclusion
of all other pets in all circumstances. In the rare event of an unauthorised pet gaining access to the feeder, Sure
Petcare cannot accept liability for any damage or inconvenience which may be incurred.
The manufacturer is not responsible for any radio or TV interference caused by unauthorised modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
Disposal of Products and used Batteries: Either of these symbols on a product indicates it is
subject to the following legislation:
Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE) & Directive 2006/66/EC on Batteries
and Accumulators require households to dispose of electrical products and waste batteries in an environmentally
responsible manner. These items should not be placed in household waste bins and must be recycled at an
appropriate recycling facility. Further information on recycling can be found at: www.recycle-more.co.uk .
FCC compliance: This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. This device has been designed and complies with the safety requirements for
RF exposure in accordance with FCC rule part §2.1093 and KDB 447498 D01.
EN
4