Emos P5614 Manual De Instrucciones página 8

The maximum range between the control and switching unit is 100 m in
an open space. The range may decrease in the interior as the signal is
blocked by walls and other obstacles.
Main Switch
To turn on the switching unit, set the switch to the position.
If the heating/air-conditioning system is not used for an extended period
of time, it is recommended to turn the switching unit off (switch the main
switch to the
Choosing Operating Mode (Heating, Cooling, Anti-Freeze
Temperature)
1. Press and hold the control wheel for 5 seconds to enter mode
settings.
2. Turn the control wheel to select one of the following modes:
a. HEAT (heating system)
b. OFF (anti-freeze temperature of 7 °C)
c. COOL (cooling system)
3. Press the control wheel to confirm your selection.
Room Temperature Calibration
Press and hold the control wheel for 5 seconds until the setting mode
indicator starts flashing on the screen.
Press and hold the control wheel again for 5 seconds until the temperature
calibration value starts flashing on the screen.
Use the wheel to set the temperature value of choice (-3.0 °C to 3.0 °C,
in 0.5 °C steps) and confirm by pressing the wheel.
Room temperature calibration is used if, for example, the thermostat
shows 21 °C but you want it to show 20 °C. In that case, the calibration
value should be set to -1 °C.
LED Indicators
Automatic Mode
In automatic mode, a red LED will glow when the thermostat switches
on the output relay.
Manual Mode
Press the MANUAL button; a green LED will light up.
To switch on the output relay, press the M/A button; a red LED will light up.
To turn off manual mode, press the MANUAL button again; the green
LED will switch off.
Display Backlighting
Pressing the control wheel activates display backlighting for 10 seconds.
position).
8