GYS KRONOS 400T DUO Manual De Uso página 122

Using the machine interface
Wire loading (MIG-MAG)
To unwind the wire in the MIG/MAG torch without using gas, please follow the procedure below:
1- Hold the trigger down in a non-welding position.
2- When the process is shown on the display, you can release the trigger.
3- The wire starts to feed. 3m of wire feeds at a speed of 5m/min by default. You can change these va-
lues with the thumbwheel.
If you wish to exit the animation without waiting for the wire to finish feeding, press the trigger briefly.
Job memory and recalls
Accessible through the «JOB» icon on the main screen.
The settings in use are automatically saved and remembered the next time you turn on the machine.
In addition to the active settings, it is possible to save and recall «JOB» configurations.
There are 200 JOBS for the MIG/MAG process and 100 for the TIG and MMA process. The storage is based on the current pro-
cess parameters, and the current settings.
Job
This JOB mode allows you to create, save, recall and delete JOBs.
1- Save As - Creating a Job
Customise the job name by pressing the thumbwheel. Confirm by pressing push-button no. 2.
Display the current job
At the bottom right of the screen, the job number is displayed.
Stop the current job
To close the current job, the user must return to the Job menu and select «Close».
2- Open - Jobs Management
The screen lists previously created Jobs.
Short presssing push-button no. 1 returns to the previous menu
Holding down push-button no. 1 ( ) deletes the selected Job or all the Jobs.
Short pressing push-button no. 2 (
QuickLoad – Recall JOBs from the trigger when not welding.
QuickLoad is a mode to recall jobs (20 max) outside of welding, and is only possible in MIG-MAG and TIG processes.
From a list of previously created JOBs, JOB recalls are done by short trigger presses. All trigger modes and welding modes
are supported.
1- New - Creating a QuickLoad
• Customise the name of the QuickLoad by pressing the thumbwheel.
• Choose the number of jobs to be recalled, between 2 and 20.
• Choose the trigger sensitivity: slow, normal or fast
• Choice of Jobs to be recalled
Press push-button no. 2 to confirm the creation of a QuickLoad.
18
) allows you to see the details of each of the previously created jobs.