Sauder 423531 Instrucciones De Montaje página 10

Step 6
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the ENDS (B and C). Use six BLACK 5/8" FLAT HEAD SCREWS (19).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the diagram. Then, slide the inner cartridge of
å
the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the END. Turn a SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever up and
pull the SLIDE from the RAIL.
BLACK 5/8" FLAT HEAD SCREW
(6 used in this step)
Page 10
2
Open end
19
B
1
Open end
www.sauder.com
1
Use these holes.
1
C
Open end
423531