Sauder 423531 Instrucciones De Montaje página 19

Step 15
Carefully stand your unit upright.
å
To insert the drawer into your unit, line up the EXTENSION
å
SLIDES on the drawer with the EXTENSION RAILS on the
unit and push the drawer into the unit until the drawer is
fully inserted. The drawer will push in hard until it is all the
way in, then it will slide in and out easier.
Fasten the DOORS (N) to the ENDS (B and C) as shown
å
in the enlarged diagram. Use sixteen BLACK 5/8" FLAT
HEAD SCREWS (19). You should start each SCREW a few
turns before completely tightening any of them.
Fasten a KNOB SET (9) to each DOOR (N). Use two
å
BLACK 1" MACHINE SCREWS (18).
Peel the BUMPERS from the BUMPER CARD (11) and
å
stick them on the DOORS (N) where they come in contact
with the WOOD BLOCK on the BRACE (F).
F
B
423531
19
BLACK 5/8" FLAT HEAD SCREW
(16 used for the HINGES)
N
9
www.sauder.com
C
N
18
BLACK 1" MACHINE SCREW
(2 used for the KNOB SETS)
Pro Tip: Lift with your
legs. And, you know,
your arms.
11
9
Page 19