Product Assembly; Operation - cecotec CONGA ROCKSTAR 2500 ULTIMATE ERGOWET CONNECTED Manual De Instrucciones

ENGLISH
- Remove the first-use tab installed in the filter.
Box contents
- Conga RockStar 2500 Ultimate ErgoWet Connected vacuum cleaner
- 2-in-1 wide accessory for corners and furniture
- 2-in-1 narrow accessory for corners and furniture
- Jaliscazo brush
- Vacuuming flexible tube
- Motorised brush for upholstery.
- Extensible tube.
- Long brush
- Union elbow
- Fabrics brush
- Water tank accessory
- 1 spare high-efficiency filter
- 1 spare mop
- Charging base
- Instruction manual

3. PRODUCT ASSEMBLY

Vacuuming tube and brush head assembly
- To install the vacuuming brush head into the vacuuming tube, align both of them making
sure the tab on the brush head matches the guides on the tube, and introduce one into the
other until they are firmly fixed.
- To disassemble them, press the vacuuming brush head release button and pull from the
vacuuming tube while you hold the vacuuming brush head.
Note
When assembling these 2 parts, make sure the handle and the brush head are facing the same
direction.
Vacuuming tube, vacuuming brush head and main body assembly
Fig. 2
To complete the installation of the device, hold the vacuuming tube with the brush head
assembled upright and introduce the tube in the main body.
Battery assembly
Fig. 3
- Introduce the battery in the slot located in the main body following the guides. Once it is
52
introduced, it will click into place. Once inserted, check that it is secured in position.
- To disassemble the battery, press the release button (Fig. 1.1) and remove the battery.
Note
Remove the battery and store it in a safe, dry place if the device is not going to be used in a
long period of time.

4. OPERATION

You can use this vacuum cleaner in two different manners:
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
- Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
Using the vacuum cleaner
- Press the On/off button to turn the device on and off.
- Press the speed button to select the device operating speed: LOW, MED, HIGH and AUTO.
The device will turn on with the LOW mode by default.
- Under this mode, the device will automatically adjust suction power according to the
concentration of dust and the type of surface.
- When operating at high speed, if the battery is at 20% or lower, the device will automatically
switch to medium speed in order to lengthen the battery life.
Using the vacuuming brush head for floors
- Assemble the vacuuming tube to the vacuuming brush head and next, assemble the main
body, as shown in the assembly section.
- Press the On/off button to turn the device on and off.
- Press the speed button to set the power level from this modes: LOW, MED, HIGH and AUTO.
- The vacuuming brush head can remove dust from carpets, hard and soft floors, and tiles.
- If too many particles or fibres are vacuumed, or if a child touches the brush during operation
by accident, the rotary brush stops spinning automatically in order to prevent tangles and
possible damage.
Accessories
Fig. 4
This device includes different accessories that allow cleaning different types of surfaces,
objects and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
CONGA ROCKSTAR 2500 X-TREME ULTIMATE ERGOWET CONNECTED
ENGLISH
53