ENGLISH
Storing the device
-
If the vacuum cleaner is not going to be used for a long time, remove the battery from the
product and store it in a dry and safe place.
Maintenance indicator
-
The full tank icon or the obstructed filter icon will be displayed if the device has not been
properly and frequently maintained. Fig. 22
8. TROUBLESHOOTING
Problem
Possible cause
The motor does not operate
The battery does not work
any longer.
The metallic tubes, floor
brushes, batteries or the
device itself are not properly
assembled.
The suction power has been
The dust tank is full.
reduced and the appliance
The filter has too much dust.
makes a lot of noise.
The electric rotary brush inlet
Fig. 23
is obstructed or the brush is
blocked.
Insufficient operating time
Insufficient charge time.
after charge.
The battery is old.
(The battery life may vary
according to the room
temperature).
9. ERROR CODES
Code
Problem
E1
The device turns off and does not
charge
58
Solution
Charge the vacuum cleaner.
Make sure all parts of
the device are correctly
assembled.
Clean the dirt.
Clean or replace the filter.
Clean the dust inside the
electric rotary brush.
Fully charge the battery
following the instructions in
this manual.
Batteries are easily
recycled. Go to the closest
maintenance point and buy
new batteries.
Cause
Short circuit
E2
The device does not charge
E2
The device does not charge
The device turns off
E3
The device turns off and displays E3
E5
The device turns off and displays E5
E6
The device turns off and displays E6
E9
The device turns off and displays E9
E7
The device stops working or does not
turn on and shows E7
E8
The device turns off and displays E8
High-
The device does not turn on Fig. 24
efficiency
filter
indicator
flashes
The filter
It works normally. Fig. 23
icon flashes
The brush
The brush and motor stop working.
icon flashes
Fig. 24
Note
-
The low battery warning will disappear when the charger is disconnected.
-
Low battery error (excluding shut down due to low battery), will stop after 6 seconds. If
not, press the on/off button to stop it.
-
Communication or NTC error: It will stop after 60 seconds.
10. TECHNICAL SPECIFICATIONS
Product reference: 05687
Product: RockStar 2500 Ultimate ErgoWet Connected
Voltage and frequency: 100-240 V ~ 50/60 Hz
29.6 V DC, 3000 mAh and 88 Wh battery
Motor rated power: 630 W
Brush rated power: 50 W
CONGA ROCKSTAR 2500 X-TREME ULTIMATE ERGOWET CONNECTED
ENGLISH
The charger voltage is below 36.3 V
The charger voltage is below 32.1 V
Low battery
The motor short-circuits when the
battery is low
Main motor overload (second level)
Main motor overload
Temperature too high or low
Battery fault (first level)
NTC error (thermistor short circuit)
High-efficiency filter not installed
The dust tank or the inlet filter is
blocked
Blocked brush
Brush full of hair
59