Watertank Accessory - cecotec CONGA ROCKSTAR 2500 ULTIMATE ERGOWET CONNECTED Manual De Instrucciones

ENGLISH
Jaliscazo brush
Assemble this brush to the upright vacuum cleaner. This brush is especially designed for
cleaning hard floors, but can be used to efficiently clean soft floors too.
2-in-1 wide accessory for corners and furniture
Fig. 5
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
2-in-1 narrow accessory for corners and furniture
Fig. 6
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
ErgoFlex vacuuming flexible tube
Use the Flex tube to reach and vacuum dirt from the most inaccessible zones. Press the Flex
button to bend the tube.
Long brush
Fig. 7-8
Suitable for cleaning surfaces which are sensible to scratches such as furniture, wardrobes,
etc.
Extensible tube
It can be assembled onto the device for a more flexible cleaning, to reach the most difficult
corners.
Motorised brush for upholstery
Fig. 9
Removes dust mites and bacteria from beds and sofas.
Union elbow
Fig. 10
Suitable for cleaning dust from high wardrobes, roofs, windows, corners, etc.
Special brush for fabrics
Adjustable accessory to remove all types of dust trapped in fabrics.

Watertank accessory

With this accessory you will mop and scrub your floor just by attaching it to the vacuum cleaner.
54
Wall charging base installation
Fig. 11
Place the charging base on the wall and mark 3 spots to be drilled to fix the base. You
1.
must take into account the height of the installation, it is important that the vacuuming
brush head rests on the floor to avoid the charging base from holding all the vacuum
cleaner's weight.
Drill the 3 holes (previously marked) and insert the pegs and M4 x 32 mm screws.
2.
Make sure that the charging base is securely fixed on the wall and place the vacuum
3.
cleaner on the charging base by placing the vacuum cleaner charging terminals over the
charging base charging terminals (plastic tab).
Once the wall charging base is installed, the charging port must be connected to the
4.
power adapter, and then the device can be charged by sliding it from top to bottom into
the wall charging base. Fig. 12
Charge and display
- When the battery percentage is 20 % or below, the device will automatically enter
low consumption mode. It is recommended to charge the device when it reaches this
percentage.
- The battery must be charged with the charging base while it is connected to the main body.
Connect one of the ends of the power adapter to the power supply and the other to the
charging base. Fig. 8
- During charging, the charge light indicator will turn on red and the display will show the
current charge percentage. When the device is fully charged, the battery indicator will turn
green and the display will show 100%. Fig. 13
- You can also charge the battery without using the charging base. You can charge the
battery when the battery is installed or not in the device. Connect the adapter and connect
the other end to the battery, paying attention to the direction. Once it is properly connected,
the charge light indicator will turn on red and will turn green once the charge is complete.
Fig. 14
5. WATERTANK ACCESSORY
- Do not use cleaning agents. Use clean and room temperature water only. Do not use the
vacuum cleaner to vacuum water.
- When the vacuum cleaner is not going to be used for a long time, please remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation
Place the mop cloth on the ground with the Velcro facing upwards.
1.
CONGA ROCKSTAR 2500 X-TREME ULTIMATE ERGOWET CONNECTED
ENGLISH
55