Flex IW 1/2 750 18.0-EC Instrucciones De Funcionamiento Originales página 16

CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Removable belt clip
Your tool is equipped with a removable belt
clip that can be positioned on the side of the
tool for convenient transport.
■ Remove the battery pack from the tool.
■ Align the rib and the hole of the belt clip 7
with the opening 8 and the threaded hole
on the base of the tool. (see figure D).
■ Insert the fastening screw 9 and securely
tighten the screw with a screwdriver (not
included).
Strap fixing
■ Strap fixing is provided to attach a wrist
strap (not included) in order to reduce the
chances of dropping your tool. Wrap the
strip around your hand when carrying the
tool (see figure E).
Install and remove the impact
socket (see figure F)
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch 5
to the middle position.
Make sure that the impact socket and the
mounting portion are not damaged before
installing the impact socket.
■ Align the square of the impact socket with the
square drive 1 and push the impact socket
onto the square drive as far as it will go.
■ Tap it lightly if required.
■ To remove the impact socket, simply pull it
off.
WARNING!
The impact socket may be hot after prolonged
use. Use protective gloves when removing
the impact socket from the tool, or first allow
the impact socket to cool down.
Direction preselection (see figure G)
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
Move the direction preselector switch 5 to the
required position:
■ Position the direction preselector switch to
the far left of the tool to tighten bolts/nuts
16
■ Position the direction preselector switch to
the far right of the tool to loosen bolts/nuts.
■ Position the direction preselector switch
in the "OFF" (center-lock) position to help
reduce the possibility of accidental starting
when not in use.
NOTE
The impact wrench will not run unless the
direction preselector switch is engaged fully
to the left or to the right.
WARNING!
Battery tools are always in operating
condition. Therefore, the direction
preselector switch should always be locked
in the center position when the tool is not
in use or when carrying it at your side.
Mode selection (see figure H)
CAUTION!
Your tool is equipped with a speed control
panel 3, located on the foot of the tool. It
consists of the drive-control button, the
"A" button, and LED indicators for working
modes.
The drive-control button is used to select
among three modes to adjust the torque,
rotation-speed (RPM), and impact-speed (IPM)
setting for an application. The modes 1, 2,
and 3 are the only modes where the speed
is controlled by the variable-speed trigger
switch.
To select the drive control mode:
■ First, check the active mode. Either depress
and release the trigger switch or press the
drive control button or "A" button directly
without touching the trigger switch. The
LED indicator below the mode number
will illuminate to indicate the active mode
setting.
■ Press the drive-control button briefly (less
than 0.5 second) to cycle through the 3
modes. Each press changes one torque
level. See more details in the chart below.
"A" is a special mode, that is designed to be
used both with forward rotation for tightening
the bolts or nuts and reverse rotation for
loosening the bolts or nuts.
■ Forward: bolt auto stop mode; the tool
stops after applying a number of impacts
to avoid fasten too tightly.
IW 1/2" 750 18.0-EC