Charging The Receiver/Collar - Dogtra Europe E-FENCE 3500 Manual De Instrucciones

CHARGING THE RECEIVER/COLLAR

Recharge the unit if :
1. The LED indicator light on the receiver/collar is emitting a red color.
2. The indicator light on the receiver will not come on.
3. The indicator light on the receiver comes on momentarily, but will not stay on
near the wire.
Battery Charging Procedure
1. Attach the charging cables to the receiver as shown.
2. Plug the charger into a 220-volt wall outlet.
When properly plugged in, all indicator lights should glow red.
During the charging process, the unit will shut off.
3. The Lithium-Polymer battery is fully charged within 2 hours.
The lights will stay red during the charging process.
The red light will change into a steady green light when the battery is fully
charged. (When you disconnect the charger after finishing the charge, you
will need to restart the units).
4. After charging, cover the battery charging receptacle with the rubber plug on
the receiver/collar.
Note : Only use Dogtra-approved batteries, chargers, and accessories for the
E-Fence 3500. Unauthorized chargers may cause the unit to malfunction and the
indicator light to blink in an amber color.
44
Dogtra uses Lithium-Polymer
batteries.
1. Charge the unit before using the unit
for the first time.
2. Do not charge the batteries near any
flammable substances.
3. Fully charge the batteries if the unit is
to be stored without use for a period
of 3 months or more.
Charger Info
Manufacturer : HON-KWANG
Manufacturing country : CHINA
Model name : HK-AP-050A100-EU
INPUT : 100~240V~50/60Hz 0.2A
OUTPUT : 5V 1.0A
Attention!
During battery charging, the unit must be close to the wall outlet and the wall
outlet must be easily accessible for security reasons.
45