SOLAC CE4520 Instrucciones De Uso página 12

Downloaded by: pd-oliana on 12-08-2022 14:11 CEST
STEAMER PIPE CLEANING
ATTENTION! All of the steamer components can be-
come very hot.
It is advisable to clean the steamer pipe after genera-
ting steam and before switching off the machine to pre-
vent a build-up of dirt.
To do this, take the sleeve off the steamer pipe.
Place a glass containing with a little water, under the
pipe and submerge the pipe in the water.
Follow the instructions in the "Hot Water" section to
make hot water come out through the pipe.
Use a cloth to dry the pipe and put the sleeve back on.
If no steam comes out, dry milk may be blocking the
outlet. In which case, carefully use a needle to unclog
the tip of the steamer pipe.
Once clean, rinse under running tap water and reas-
semble it. Generate some more steam.
HOW TO DEAL WITH LIME
SCALE INCRUSTATIONS:
For the appliance to work correctly it should be kept free
of limescale or magnesium deposits caused by using
hard water.
To prevent this kind of problem, we recommend the use
of water with low lime or magnesium mineralisation.
The coffee maker tells you when descaling is needed
by beeping and the three lights switch on without flas-
hing.
When this happens, fill the tank with 1L of water and
add a descaling agent (citric acid, descaler...)
Access the programming menu as described earlier in
the manual.
Place a large container (enough to hold 1L water) under
the steamer pipe.
Open the steam control to the MAX position.
Press the steam heating button again and the machine
will begin the descaling process. This process takes
about 5 minutes.
A specific anti-lime scale product should be used on this
kind of product.
NOTE: Should you also want to clean the entire coffee
system, you can alternate the flow of water by using the
steam control.
NOTE: Home-made solutions, such as the use of vine-
gar, are not recommended for de-scaling this appliance.
Once the operation has finished, refill the tank with
clean water and go through the process again, but
without descaling agent, to eliminate any remains left
inside the machine.
Once finished, clean the water tank and the machine is
now ready for use.
FAULTS AND REPAIR
Take the appliance to an authorised technical support
service if problems arise. Do not try to dismantle or re-
pair it, as this may be dangerous.
Lit button warnings
Operation LED indicators
The machine is
On/Off
preparing itself.
Start of the Flashing: Pre-heating.
coffee brewing Steady: Ready to make
function coffee.
Flashing: Pre-heating.
Start of the
steam function
Steady: Ready for steam
Open steam Flashing: Reminder to
control close the steam control
Thermoblock Steady: It needs to cool
too hot. down.
Descale The 3 lights light up.
warning. Proceed with descaling.
The 3 lights flash
NTC fault.
simultaneously.
EN