Britax ADVANSAFIX II Manual Del Usuario página 3

ADVANSAFIX II / ADVANSAFIX II SICT
When installing with „semi-universal" approval please observe the following list of
vehicles.
-> Please observe the specifications on this in your vehicle manual.
The ADVANSAFIX II / ADVANSAFIX II SICT
method of installation:
„Semi-universal"
with the vehicle's 3-
point seat belt, Top
Tether and the
ADVANSAFIX II
locking arms into the
ISOFIX fastening points
This means: the child car seat can be installed
using the vehicle´s 3-point seatbelt *, the Top
Tether and the
ADVANSAFIX II
using the ISOFIX fastening points. However,
this method of installation may only be used in
those vehicles cited in the following vehicle type
list.
• This type list is constantly updated. The latest
version can be obtained from us or from our
homepage: www.britax.eu
• Caution! Always secure your child with the
vehicle´s 3-point seat belt * or the integrated
5-point-harness (depending on the method of
installation).
• Please note: In some vehicles the headroom
in the rear seat is limited. If you fasten the
ADVANSAFIX II / II SICT
ADVANSAFIX II
vehicles, it may not be possible to use
the child seat up to a body height of
1.50 m. This may be the case, for
example, if the
ADVANSAFIX II / II SICT
headrest hits the vehicle's C-pillar.
Please observe the heights shown in the type
list.
2
locking arms
with the
locking arms in these
is approved for the following
*
3-point automatic seatbelt
(in accordance with ECE R 16 or comparable standard)