Stihl TS 700 Manual De Instrucciones página 29

Checking the adjustment range of the
guard
A
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
Outboard mounting (TS 800)
Disassemble the abrasive wheel
N
(see "Fitting / replacing an abrasive
wheel")
TS 700, TS 800
Removing the water attachment
2
Unscrew the banjo bolt (1) with the
N
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
Remove the water hose (2) with
N
connector from the adjusting
lever (3)
Unscrew the screw (4)
N
Removing the adjusting lever
3
2
1
Unscrew the banjo bolt (1) with the
N
combination wrench and remove it
together with the seal – in the
process, remove the square nut
from the inside of the guard from the
guide
Unscrew the screw (2)
N
Turn the adjusting lever (3) upwards
N
and remove
Remove the sealing plug (4)
N
Slackening the V-belt
3
4
1
To relax the poly V-belt, loosen the
N
nuts (1) – do not unscrew the
nuts (1) from the studs
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
Unscrew nuts (1) from the studs –
N
nuts (1) are fastened to the belt
guard so that they are secured
against loss
4
English
1
1
2
1
27