Nederman FlexPAK Manual Del Usuario página 37

• The software version is found on a label
taped to the front of the PLC. LOGO 8 soft-
ware is updated using an SD Card. Follow the
included instructions when the software
needs to be updated.
• To find the firmware and software revision
number in the PLC display, see
1. Pressing 'OK' when the PLC displays this
menu will show this information. See also the
PLC Settings Manual.
The firmware and software revision can be read in the
PLC and also on the label on the PLC.
The number, 2155264-2-EN for example, consists of
the following parts:
• 2155624 = The software number.
• 2 = The revision.
• EN = The language of the display text.
LOGO 8 software is updated using an SD Card. Care-
fully follow the included instructions when the soft-
ware needs to be updated.
Use only Nederman original spare parts and ac-
cessories.
Contact your nearest authorized distributor or
Nederman for advice on technical service or
if you require help with spare parts. See also
www.nederman.com.
When ordering spare parts always state the following:
• The part number and control number (see the
product identification plate).
Figure 8, item
• Detail number and name of the spare part (see
www.nederman.com/en/service/spare-part-
search).
• Quantity of the parts required.
The product has been designed for component mater-
ials to be recycled. Different material types must be
handled according to relevant local regulations. Con-
tact the distributor or Nederman if uncertainties arise
when scrapping the product at the end of its service
life.
The following environmental information is valid for
FlexPAK:
• Cadmium-free and halogen-free relays in the control
equipment.
• Solvent-free washing and lacquer.
• 93,6% recyclable.
37