Checking Chain Lubrication - Stihl HTE 60 Manual De Instrucciones

10 Checking Chain Lubrication

► Close the bracket lock
The fuel cap is locked
If the oil level in the tank does not go down, the
reason may be a problem in the oil supply sys‐
tem: Check chain lubrication, clean the oilways,
contact your dealer for assistance if necessary.
STIHL recommends that maintenance and repair
work be carried out only by authorised STIHL
dealers.
9.5 If the fuel cap will not lock onto
the oil tank
The base of the fuel cap is tilted in relation to the
upper part.
► Remove the fuel cap from the oil tank and look
at it from above
left: Base of fuel cap is tilted – interior
marking (1) is aligned with the exte‐
rior marking
right: Bottom of the fuel cap in correct
position – inner mark is under the
grip. It does not align with the exte‐
rior marking
0458-247-9921-C
1
► Fit fuel cap and twist it counterclockwise until it
engages in the seat of the filling port
► Continue to twist the fuel cap counterclock‐
wise (approx. 1/4 turn) – this will twist the base
of the cap into the correct position
► Twist the fuel cap clockwise and close it – see
section "Closing"
10 Checking Chain Lubrica‐
tion
The saw chain must always throw off a small
amount of oil.
NOTICE
Never operate your machine without chain lubri‐
cation. If the chain runs dry, the whole cutting
attachment will be irretrievably damaged within a
very short time. Always check chain lubrication
and the oil level in the tank before starting work.
Every new chain has to be broken in for about 2
to 3 minutes.
After breaking in the chain, check chain tension
and adjust if necessary – see "Checking Chain
Tension".
English
37