Checking Chain Lubrication; Fitting The Harness - Stihl HT-KM Manual De Instrucciones

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
HT-KM

Fitting the Harness

The type and style of the harness,
carrying ring and carabiner (spring hook)
depend on the market.
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attaching Machine to Harness
1
2
Attach the carabiner (1) to the
N
1
carrying ring (2) on the drive tube –
hold the carrying ring steady.
Detaching Machine from Harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing Off the Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
power tool as you would in an
emergency. To avoid damage, do not
throw the power tool to the ground when
practicing.
English
2
1
1
2
19