Vito Agro VIM7 Manual De Instrucciones página 44

1. Remove the locking pins from the work accessories fixed
holder;
2. Hook the accessories holder on the fixed holder middle
hole. Place the locking pin and the beta key;
3. Insert the depth bar in the accessory's holder. Place the
fixing pin on one of the depth bar's holes according to
the desired height and place the beta key.
4. Regulate the depth bar with the adjusting screw;
5. Regulate the work accessories holder fixing angle with
both adjusting screws.
t
Check if the traction lever is disengaged and the
speed lever is on neutral to avoid a sudden and
uncontrolled movement as the engine starts.
1. Close the air filter, place the air lever to the left;
2. Open the fuel tap place on position "ON", the knob must
be on the right.
3. Place the throttle knob in the middle, press "ON" in the
"ON/OFF" switch;
4. Pull slowly the starter grip until feel some resistance and
then pull harder until the engine starts working;
5. After about 30 seconds, open the air filter, move the air
lever until it's placed on the right.
Do not close the air filter if the engine is warm or if the air
temperature is high.
1.
2.
1. Press the traction locking lever;
2. Grab the traction lever and the traction shaft starts
running;
3. When you release the traction lever the traction shaft
stops.
3.
To activate the
traction shaft
1. Grab the locking lever and the reverse lever;
2. Press the locking lever and grab the traction lever;
3. When the traction lever is pressed the gearbox activates
the traction shaft;
4. When the traction lever is released, the traction shaft
stops.
When stepping back, keep a safety distance and hold
the handlebar firmly to avoid tripping and getting
stuck under the machine.
1. The speed lever must be handled when the traction lever
is loose;
2. The speed lever allows to select three positions
according to the desired operation: 0, 1 e 2;
3. After selecting the desired speed grab the traction lever
and the traction shaft starts running.
The starting movement may be quite abrupt.
To stop the
traction shaft