Sartorius Flexsafe Pro Mixer Drive Unit Instrucciones De Manejo página 49

10 Malfunctions
10.1 Warning Messages
Warning Message Malfunction (Info)
[Mixing warning: [The measured
Mixing motor position has
position] changed more than
2 mm from the initial
position]
[Mixing warning: [No cart-in-place
Cart-in-place sensor signal]
sensor]
[Coupling warning: [No impeller
Impeller] detected in the
mixing position]
[Lifting system [Lifting system top
warning: Top end end position
position reached] reached.]
10.2 Error Messages
Error Message Malfunction (Info)
[Lifting system error: [Lifting motor does
Motor timeout] not reach position.
(Sensor or motor are
damaged)]
Cause Solution
During the mixing Check whether the impeller is
process, the moving correctly and freely
distance sensor (visual check in Palletank
measures a signal mixing).
that deviates from
If required: Check the coupling
the output signal by
of the device.
more than 2 mm.
During the mixing Check the coupling of the
process, the device.
Palletank
®
recognition sensor
loses the signal.
The motor has Stop the mixing process.
reached the end
Decouple the device from the
position and cannot
impeller and Palletank
recognize the
mixing.
impeller.
Check whether the impeller is
correctly installed in the
Palletank
instructions for the Palletank
for mixing).
Couple the device with the
impeller and Palletank
mixing.
The motor has Check that the distance sensor
reached the top end on the device or the alignment
position and has not pin of the Palletank
detected the adjusted (see Palletank
alignment pins of
the Palletank .
®
Cause Solution
The motor cannot Please contact Sartorius
be correctly Service.
started-up, because
the motor and other
components are
damaged.
Operating Instructions Flexsafe
Malfunctions
Chapter,
Page
for
®
10.6,
52
10.6,
52
8.12.1,
for 45
®
for mixing (see
®
®
8.6,
for 42
®
8.5,
40
is correctly
®
guide).
®
Chapter,
Page
Pro Mixer Drive Unit
®
49