Sartorius Flexsafe Pro Mixer Drive Unit Instrucciones De Manejo página 51

Error Message Malfunction (Info)
[Mixing motor error: [Power consumption
Bearing current] too high]
[Mixing motor error: [Impeller is
Impeller unstable] unstable]
[Mixing motor error: [Open drive coil]
Drive coil]
[Mixing motor error: [Controller power
Power output] output short circuit
or overtemperature]
[Mixing motor error: [The rpm of the
Speed lost] impeller is 0]
[Mixing motor error: [No impeller in the
No impeller drive – either not
detected.] present or too far
away.]
Cause Solution
The storage current Check the position of the
is too high, causing mixing bag and impeller.
the mixing process
to be interrupted or
locked.
The impeller in the Check the position of the
mixing bag is mixing bag and impeller.
unstable, causing
the mixing process
to be interrupted or
locked.
The Motor has a Switch off the device.
fault, causing the
Check whether the power
mixing process to be
supply cable is properly
interrupted and
connected.
locked.
Switch on the device.
The listed output is Switch the device off and on
exceeded, causing again.
the mixing process
to be interrupted
and locked.
The mixing speed Stop the mixing process.
decreases to 0
during the mixing
Decouple the device from the
process and does
impeller and Palletank
not increase again
mixing.
within 10 seconds.
Couple the device with the
impeller and Palletank
mixing.
The impeller is not Check the position of the
recognized. mixing bag and impeller.
Operating Instructions Flexsafe
Malfunctions
Chapter,
Page
10.5,
52
10.5,
52
6.1.2,
30
8.12.1,
for 45
®
8.6,
for 42
®
10.5,
52
Pro Mixer Drive Unit
®
51