8. SECURING THE FRONT SHELF BRACKETS
Parts Required:
1
x
Front Shelf Bracket / Left (#18)
1
x
Front Shelf Bracket / Right (#19)
6
x
Screw (#A)
Installation:
•
Attach one Front Shelf Bracket to the front of the grill barrel by using
three screws. Install each screw halfway, then tighten completely
when all three screws are mounted and aligned properly.
•
Repeat the same installation for the other Front Shelf Bracket.
9. INSTALLING THE FRONT SHELF
Parts Required:
1
x
Front Shelf (#20)
2
x
Washer (#B)
2
x
Screw (#H)
2
x
Nut (#I)
2
x
Bushing (#J)
Installation:
•
From underneath, insert the screw (from the outside) into the Front
Shelf Bracket and the Front Shelf, then add the bushing onto the
screw, the washer, then the nut. Repeat installation for the other side
of the Front Shelf.
NOTE: When installed correctly, the Front Shelf can be raised (for
use)and lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.
10. INSTALLING THE FLAME BROILER™ COMPONENTS
Parts Required:
1
x
Flame Broiler™ Slider (#5)
1
x
Flame Broiler™ Main Plate (#6)
1
x
Flame Broiler™ Adjusting Bar Handle (#13)
1
x
Flame Broiler™ Adjusting Bar (#14)
Installation:
•
Insert the Flame Broiler Main Plate into the Main Grill, right side first.
Rest the Flame Broiler Main Plate on the built-in ledge (on the inside
right) of the Main Grill that directs grease towards the grease bucket.
Slide the entire piece to the left side, and the two slots on the Flame
Broiler Main Plate will fit into the rounded ledge above the Burn Pot.
It will sit slightly at a downward angle. Note 10A.
IMPORTANT: If the Flame Broiler Main Plate is on the base of the
barrel, it is installed incorrectly. The Flame Broiler Main Plate should
sit at an angle, with the left side sitting higher than the right. Poor
installation of this part may result in damage to your Main Grill
barrel.
10
8
18
A
9
J
I
B
H
20
10A
19
6