Pit Boss PRO Serie Montaje Y Operación página 24

The Digital Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical
shorts, consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
110-120V, 60Hz, 315W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and certification services, comply
with a testing tolerance of ± 5-10 percent.
FUEL INPUT
RATING:
2.0 KG/H
(4.4 LB/H)
GROUNDED
POWER CORD
SILICON NITRIDE IGNITER
110-120V, 240W
INDEX
K : BLACK
W : WHITE
R : RED
Y : YELLOW
P : PURPLE
O : ORANGE
G : GREEN
24
ELECTRICAL WIRE DIAGRAM
LOCATE AND REMOVE
THE EIGHT SCREWS
OF ACCESS PANEL ON
UNDERSIDE OF UNIT
TO ACCESS HOPPER
COMPONENTS
CONTROL BOARD
GROUND
AUGER MOTOR
& FEED SYSTEM
110-120V, 60Hz,
2 RPM MOTOR
LOCATE AND REMOVE
THE TWO SCREWS
OF CONTROL PANEL ON
FRONT OF UNIT TO
ACCESS THE WIRES OF
THE COMPONENTS
GRILL PROBE
LIGHT
DRAFT FAN
110-120V, 60Hz,
1 PHASE