Publicidad
Idiomas disponibles
Idiomas disponibles
Unpairing procedure
1. From the current screen ("RF x") press the button
2. Press the button
At this point the device will be unpaired and it will be possible to continue with a new unpairing.
3. Press the button
Pairing procedure
1. From the current screen ("RF - -") press the button
2. Put the Bridge in standby for pairing by pressing the middle button for about 5 seconds (the left LED will
start blinking). Bridge standby status lasts for 10 seconds.
3. Press the button
Bridge is in progress. If the procedure is completed successfully, the display will show "dE" together with
the value of the local address received from the paired Bridge. In case of failed procedure, the indication
"In" will appear again and the procedure will have to be repeated.
4. Press the button
3.3 (Step 3) Correct setting of time and day
1. Press the button
where DAY 1 is Monday and DAY 7 is Sunday.
2. Press the button
from 00 to 23.
3. Press the button
utes from 00 to 59.
4. Press the button
. If the unpairing is successful, "In" will appear on the screen
to return to the main screen.
. ">>" will appear for a few seconds to indicate that the procedure for pairing with the
to return to the main screen.
. The day starts blinking: press the buttons
. The hour starts blinking: press the buttons
. The minutes start blinking: press the buttons
.
code 3542A980 - Rev. 00 - 01/2022
: "de" will appear.
: "In" will appear.
/
/
/
to set the correct day
to set the correct hour
to set the correct min-
EN
75
Publicidad
