Ferroli ROMEO N RF Manual De Usuario página 83

By adjusting the curve to 0 the Sliding Temperature is disabled.
The system must be adjusted, during installation, by qualified personnel. The user can still make further adjust-
ments for better comfort. If the room temperature is lower than the desired value, it is advisable to set a higher
order curve and vice versa. Proceed by increasing or decreasing in steps of one and check the result in the room.
Once the Compensation curve is set, it is possible to adjust the parallel offset of curves from 20 to 40 as shown
in the following graphs:
90
85
80
70
60
50
40
30
20
20 10
Temperatura esterna
1. Press the button for 3 seconds.
2. The display shows parameter CU.
3. Press the button until the parameter OF is displayed.
Press the buttons
button pressed the value will change rapidly.
4. Press any other button to exit the menu.
10 9 8
7
6
5
4
3
2
1
0 -10 -20
°C
/ to modify the parallel offset of curves in 1°C increments. By keeping the
code 3542A980 - Rev. 00 - 01/2022
90
10 9 8
85
80
70
60
50
40
30
20
20 10 0
Temperatura esterna
7 6 5
4
3
2
1
-10 -20
°C
EN
83