Ferroli ROMEO N RF Manual De Usuario página 87

3. Press the button repeatedly until parameter P5 is displayed.
Set to 0 using the buttons
activate manual system filling. Set to 2 using the buttons
4. Press any other button to exit the menu.
Attention: Set manual filling on the boiler control board. In manual operation and if the sensor installed in the
boiler detects insufficient pressure, the bar icon will blink on the display; pressing the button
the special solenoid valve. During manual or automatic system loading, the bar icon will become steady. Once
the nominal pressure has been re-established, the REMOTE will return to the normal display.
4.8 Temperature unit of measure selection
Follow the instructions below to use the REMOTE in °C or °F.
1. Press the button for 3 seconds.
2. The display shows parameter CU.
3. Press the button repeatedly until parameter P6 is displayed.
Set to 0 using the buttons
Set to 1 using the buttons
4. Press any other button to exit the menu.
/ to deactivate the electric filling device. Set to 1 using the buttons
/ to select °C.
/ to select °F.
code 3542A980 - Rev. 00 - 01/2022
/ to activate automatic system filling.
/ to
will activate
EN
87