Ferroli ROMEO N RF Manual De Usuario página 84

Sliding Temperature - Compensation according to room temperature.
As the room temperature approaches the setpoint, the temperature of the heating system is further adjusted in
order to reach the desired value as accurately as possible, without excess heat and energy waste, significantly
improving room comfort for the user.
4.3 Enable DHW programming
Follow the instructions below to enable DHW programming.
1. Press the button for 3 seconds.
2. The display shows parameter CU.
3. Press the button repeatedly until parameter P1 is
displayed. Set the desired value using the buttons
/ :
0: program disabled, continuous comfort both in
summer and winter.
1: program enabled only in winter
2: program enabled in summer and winter
3: program disabled, continuous economy both in
summer and winter.
4. Press any other button to exit the menu.
EN
84
To set the automatic weekly program, proceed as
described in par. "Step 4". Setting the automatic weekly
program, selecting the faucet symbol at point "1"and
considering that at point "3" EC (Economy) or CO
(Comfort) will be set instead of a temperature value. In
fact, the REMOTE has a weekly time programmer based
on two levels: during the COMFORT level the boiler
will maintain storage at the set temperature; during
the Economy level the boiler will not deliver domestic
hot water. Regarding the type of storage, refer to the
boiler documentation.
Attention: Make sure the REMOTE is switched to Winter
mode and to automatic operation.
code 3542A980 - Rev. 00 - 01/2022