Protocol Type; Set Max Ch And Set Dhw - Ferroli ROMEO N RF Manual De Usuario

Set the room temperature value that the REMOTE will adjust when the contact closes (if parameter
P8 has been set to 1) by pressing the buttons
pressed the value will change rapidly.
6. Press any other button to exit the menu.
Changing the operation mode of the REMOTE on opening or closing of the telephone contact can take place
with a maximum time of 60 seconds.

4.11 Protocol type

Follow the instructions below to check the type of protocol used.
1. Press the button for 3 seconds.
2. The display shows parameter CU.
3. Press the button until parameter OT is displayed.
4. Check that it is set to "1".

4.12 Set Max CH and Set DHW

Follow the instructions below to check if the heating and DHW setpoints can be both read and written in the boiler
(0 = default), or only written (1).
1. Press the button for 3 seconds.
2. The display shows parameter CU.
3. Press the button until parameter FS is displayed.
4. Check that it is set to "1".
/
code 3542A980 - Rev. 00 - 01/2022
in 0.1°C increments. By keeping the button
EN
89