Decathlon HB500 Modo De Empleo página 11

6. Maintenance, inspec ons and checks
ATTENTION!
Always ensure that the wheels are correctly locked (see par. 6.5).
●
Always ensure that the lights, bell and reflectors are correctly posi oned (see par. 6.2)
●
The handbike should be regularly checked to ensure it remains efficient and safe.
●
Insufficient maintenance and improper use of the device may cause damages and injury to people
●
or property.
There is no real danger of personal injury when using the handbike as it has been designed to
●
reduce the risk of accidents during use or prepara on for use. However, as this is a specialist
product that could become dangerous if used in different contexts, we recommend using only
original or manufacturer-approved spare parts when replacing certain components.
Should you encounter any difficul es in finding spare parts on the market, please contact
●
DECATHLON.
Each week :
Check the tyre pressures. On the side of each wheel cover, you'll find the recommended tyre
●
pressure. A deflated tyre compromises the smooth opera on of the Handbike.
Check the efficiency of the brakes (see par 6.3).
●
● Check that the gear and brake cables are not entangled.
Each quarter:
Ensure that the rear wheel bearing bolts are securely fastened.
●
Verify the efficiency of the bearings on the front and rear wheels and lubricate if necessary. We
●
recommend using silicon oil as a grease, as it's effec ve and non-staining.
Check the posi on of the gear shi (see par.6.4).
●
6.1 R eplacing the tyre and air chamber
Disassembling the tyre and air chamber
Deflate the tyre
●
Install a special lever between the circle and the shoulder of the tyre, so that when the lever is lted,
●
the side of the wheel comes out (fig. 1 and 2)
Install another lever 100 mm from the previous point and repeat the opera on (fig. 3)
●
Slide the two levers around the whole circle to release the en re tyre.
●
Remove the air chamber, star ng with the side opposite the infla on valve (fig. 4)
●
Once the air chamber has been removed, you can easily remove the tyre to replace either or both of
●
them.
Assembling the air chamber and tyre
Remove the air chamber (deflated) in the tyre (fig. 5).
●
Insert the air chamber infla on valve into the whole intended for this purpose, located on the circle.
●
Around the whole circle, install the tyre, taking note of the direc on of the tyre, which indicates
●
whether it's the right or le drive wheel.
Install the opposite shoulder over the tyre, star ng from the point where the valve is, moving round in
●
both direc ons.
Insert the final part of the shoulder with the help of the levers intended for this, reversing the
●
instruc ons shown in Fig. 3, Fig. 2, and Fig. 1.
Inflate the tyre to the pressure indicated on its side.
●
10