Decathlon HB500 Modo De Empleo página 7

3.1 First use
Set-up must be performed before using the device and must be done by the user or the person assis ng
him/her.The handbike is shipped with the rear wheels removed. Posi on the rear wheels and secure them
using a 6 mm Allen key (supplied).It is recommended you check the pressure of the wheels before use,
ensuring they're at 9 BAR. The infla on pressure is indicated on the sides of the tyre covers. However, it is
recommended that you always ensure that the wheels are properly secured before using the handbike.
3.2 Base configura on
The TW500 wheelchair comes with the following adjustment:
Seat width
Drive wheels
Seat depth
Backrest height
Backrest incline
Front height of the seat in rela on to the ground
Rear height of the seat in rela on to the ground
Camber
Derailleur
Cushion H 30mm
4. Adjustments
4.1 Rear seat height adjustment
To func on properly, the carriage mount should be as parallel as possible to the ground. To adjust the rear
height:
Loosen but do not remove screws "F4" and "F3" (see 4.2)
●
Unscrew and remove the "4" screws.
●
● Posi on the rear seat at the desired height, aligning the holes in the plate.
Replace the "D" screws and ghten them properly.
●
Tighten the F4 "F3" screws
●
Ensure that the screw posi ons on the plates are the same on both sides.
L 400 mm
W 26"
D 420 mm
HS 350 mm
IS 91°
FH 500 mm
RH 420 mm
C 12°
8 gears on the hub
400 x 420 mm
6