Cameo X3 TW Manual Del Usuario página 14

OPERATION
PLEASE NOTE
• As soon as the spotlight is correctly connected to the power supply, the following are display-
ed in succession: "Update wait ..." (for service purposes only), "Welcome to Cameo", the model
name and the software version. After this process, the spotlight is ready for operation and the
previously activated operating mode is launched.
• The main display is activated automatically if no input is made within approximately 30 se-
conds.
• If one of the DMX operating modes is activated and there is no DMX signal at the DMX input, the
characters in the display start flashing. Turning the encoder now activates the Quicklight mode
and you can set the total brightness from 000 to 255 as desired (CW and WW each preset to value
255).
MAIN DISPLAY
The main display shows the currently activated mode (in the example DMX mode with DMX start
address 001).
SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press the encoder to enter the main menu. Now select the menu
item DMX Address and confirm. Set the desired DMX start address and confirm the entry (hig-
hest value depends on the currently set DMX operating mode).
14