Adjusting The Bevel Stops - Delta 36-6013 Manual De Instrucciones

Scie sur table portable contracter de 10 po sierra de mesa de contratista portátil de 10 pulgadas
Ocultar thumbs Ver también para 36-6013:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTING THE BEVEL STOPS

If the blade is not vertically square with the table, you must adjust the 0-degree positive stop located on the inside of the bevel
track at the left end of the bevel track opening as shown in Figures 29 and 29a.
Unlock the bevel/height adjustment locking lever and position the adjustment wheel to the right in order to gain easy access to the
0-degree positive stop. Then lock the adjustment lever.
Turn the 0-degree positive stop set screw to right or left to adjust stop location.
Unlock the adjustment wheel, return the blade to the 0-degree position, making sure it makes contact with the positive stop, and
re-lock the adjustment wheel in place.
Recheck the position of the blade to the table surface using a framing square (See "SQUARING THE BLADE VERTICALLY TO THE
TABLE" ON THIS PAGE).
Continue repeating previous two steps until the blade is vertically square to the table.
You can use this same procedure in order to check the 45-degree positive stop, located at the far right end of the bevel track
maximum 45°, just inside the bevel track opening as shown in Figures 28 & 28a.
MAKING ADJUSTMENTS
FIGURE 28
UNLOCK
LOCK
FIGURE 29
LOCK
28
a
45°
UNLOCK
a

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido