Unpacking; Package Contents - Delta 36-6013 Manual De Instrucciones

• The machine is heavy, two people are required to unpack
and lift.
• Use a safety strap to avoid tip over when lifting machine.
• Prior to tool assembly and use, read this manual thoroughly
to familiarize yourself with proper assembly, maintenance
and safety procedures.
Check shipping carton and machine for damage before
unpacking. Carefully remove components in top foam layer.
Remove the top layer of foam then remove all components
in the bottom layer of foam. Lay out all parts on a piece of
cardboard or other clean, flat surface. Two or more people
are needed to lift the saw out of the carton. Always check for
and remove protective shipping materials around motors and
moving parts. Do not discard shipping carton and packing
materials until you have carefully inspected the contents,
assembled the machine and are satisfied that it operates
correctly.
PACKAGE CONTENTS DESCRIPTION (QTY)
A. Saw
J. Fence
K. 10 in. Carbide Tipped Blade
L. Miter Gauge
M. Blade Guard Assembly

UNPACKING

N. Anti-Kickback Pawls
O. Throat Plate
The following items can be found in their
respective storage areas located on the saw:
a. Blade wrenches (2)
b. Push Stick
A
L
K
O
Compare package contents to Component Parts List and
Hardware Package List prior to assembly to make sure all items
are present. Carefully inspect parts to make sure no damage
occurred during shipping. If any parts are missing, damaged
or pre-assembled, do not assemble. Instead, call DELTA
Customer Care at 1-800-223-7278 for assistance.
After assembly remove any protective materials and coatings
from all of the parts and the table saw. The protective coatings
can be removed by spraying WD-40
off with a soft cloth. This may need to be redone several times
before all of the protective coatings are removed completely.
After cleaning, apply a good quality paste wax to any
unpainted cast iron surfaces. Make sure to buff out the wax
before assembly.
a
b
M
J
9
on them and wiping them
®
N
®