Height Adjustment Knob Installation; Blade And Guards; Attach The Blade - Delta 36-6013 Manual De Instrucciones

HEIGHT ADJUSTMENT KNOB INSTALLATION

1.
Insert wheel handle shoulder screw (jj) into height adjustment wheel knob (kk) as shown in Figure 1.
2.
Tighten shoulder screw with Phillips Screw Driver into the Hand Wheel. Height adjustment wheel knob should rotate freely
around shoulder screw when raising or lowering the blade with the Height Adjustment Hand Wheel.

BLADE AND GUARDS

Attach the Blade

After installing height adjustment knob as shown in Figure 1, raise motor/arbor assembly to the upper most position to provide easy
access to riving knife lock lever and arbor assembly. Ensure riving knife lock lever is in unlock position. See Figure 2. Detach the
on-board wrenches located on the right side of the saw by loosening and removing M8 wing nut. Place the open-ended wrench (a)
on the spindle shoulder between the arbor flange and inner flange. Place the closed end wrench (a) over the arbor nut. Holding the
spindle shaft in place, loosen and remove the arbor nut and arbor flange. See Figure 2.
cutting. NOTE: Use only 10" (254 mm) diameter blades with 5/8" (16 mm) arbor holes, rated at 5,000 rpm or higher, 0.10" (2.6
mm)min. kerf width and 0.073" (1.85 mm) max body thickness. Only use 10 in. blades designed for woodcutting. Use only a saw
blade diameter in accordance with the markings on the saw.
ASSEMBLY
jj
kk
FIGURE 1
a
FIGURE 2
11
UNLOCK
POSITION
CLOSED END
WRENCH
Only use 10 in. blades designed for wood