Descargar Imprimir esta página

Pentair FLOTEC SIMER Serie Manual Del Propietário página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY INSTRUCTIONS
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The word NOTE indicates special instructions that are important
but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
DO NOT TOUCH AN OPERATING MOTOR. Modern
motors can operate at high temperatures. To avoid burns when
servicing pump, allow it to cool for 20 minutes after shut-down
before handling.
Pump is designed as a lawn sprinkler only. To avoid heat
buildup, over-pressure hazard, and possible injury, do not
use in a pressure tank (domestic water) system. Do not use
as a booster pump; pressurized suction may cause pump
body to explode.
Do not allow pump or piping system to freeze. Freezing can
damage pump and pipe, may lead to injury from equipment
failure, and will void warranty.
Pump only water with this unit.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
properly store all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Make workshops childproof; use padlocks and master
switches; remove starter keys.
P15006 (02-01-2023)
ELECTRICAL SAFETY
Wire motor for correct voltage. See "Electri cal" section of
this manual and motor nameplate.
Ground motor before connecting to power supply.
Meet National Electri cal Code, Canadian Elec tri cal Code,
and local codes for all wiring.
Follow wiring instructions in this manual when connecting
motor to power lines.
Hazardous voltage. Can shock, burn, or
cause death.
Ground pump before connecting to power
supply.
3

Publicidad

loading