Publicidad
Idiomas disponibles
Idiomas disponibles
GB
GENERAL SAFETY
For your own personal protection and for the safety of those around you, please read and ensure you fully understand the following
safety information. It is the responsibility of the operator to ensure that he/she fully understands how to operate this equipment safely.
If you are unsure about the safe and correct use of the machine, consult your supervisor or Altrad Belle.
WARNING
This machine is designed to eliminate the possible risks arising from the use of it. However, risks DO reside, and these residual risks
are not clearly recognizable, and may cause personal injury or property damage, and possible death. If such unpredictable and
unrecognizable risks become apparent, the machine must be stopped immediately, and operator or his supervisor must take
appropriate measure to eliminate such risks. It is sometimes necessary that the manufacturer must be informed of such event for
future counter measuring.
ALWAYS keep the Operator's Manual and any other manuals that accompany this machine to hand. Immediately replace any
manuals that may have been lost or are now illegible.
PRE-START CHECKS
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use,
1. Thoroughly inspect the machine for signs of damage. Check components are present and secure.
2. ENSURE there is no debris or excessive dirt present on the machine.
3. ENSURE the battery pack is securely attached to power unit and the power cable is connected.
4. ENSURE
Once all the above checks have been made, test run the machine checking that all switches function correctly and all indicators light
when the power unit is turned on.
WORKSITES
•
ENSURE the operator is familiar with the working surroundings. Worksites can be hazardous.
•
ALWAYS keep the work area tidy and clear of any obstructions that may lead to accidents and/or injuries.
•
This machine is heavy and must not be lifted single-handedly, either GET HELP or use suitable lifting equipment. A Wheel Kit
Transport option is also available for this machine (see our website Altrad-Belle.com
OPERATING THE MACHINE
•
ENSURE the operator has had adequate training prior to use, is familiar with all controls and knows how to safely switch the
machine OFF before it is switched ON
•
Suitable PPE MUST be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe
loose jewellery that could be caught in moving parts
•
ALWAYS inform colleagues of what you will be doing and where you will be working.
•
DO NOT
•
NEVER leave the power unit running and unattended.
•
NEVER
security, if any are damaged or missing, DO NOT USE THE MACHINE until the guard has been replaced or repaired.
•
When working on a gradient ALWAYS work up and down the slope, not across.
•
ALWAYS
•
ENSURE extra care is taken when working near to banks or trenches where there is a danger of the material collapsing.
•
When working within trenches or pits ALWAYS pay attention to the side walls as the vibration from the machine could cause them
to collapse.
•
Some vibration from the compaction operation is transmitted through the handle to the operator's hands. The Altrad Belle Plate
•
The compacting process will occasionally produce dust, which may be hazardous to your health. Always wear a mask that is suited
to the type of dust being produced.
Safety Instructions
Improper maintenance can be hazardous. Read and Understand this section before you perform any
maintenance, service or repairs.
DO NOT exceed the maximum usage times.
16
DO NOT wear
Publicidad
