Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING THE BATTERY PACK
Refer to the Battery Charger manual for instructions on how to charge the Battery Pack.
ATTACHING THE BATTERY PACK
CAUTION
ALWAYS make sure to use a genuine, recommeded Battery Pack.
Refer to the Machine Description section to identify the components.
1. Make sure there is no debris or dirt on the battery tray.
2. Tilt the Battery Pack and insert its claw into the battery hook.
3. Push down the Battery Pack and hook the battery fastener to it.
5. Remove the battery connector cap from the power cable. Connect the power cable to the battery connector of the Battery Pack.
STOPPING THE POWER UNIT
Refer to the Machine Description section to identify the components.
1. Press the START/STOP switch to the STOP position. The DC Power Unit will stop and the POWER
STARTING THE POWER UNIT
Refer to the Machine Description section to identify the components.
1. Press STOP on the START/STOP switch.
2. Press the POWER button.
All the indicators should illuminate for a few seconds, and then only the POWER indicator remains illuminated.
3. Press the START/STOP switch to the START position to start the Power Unit.
4. Push the SPEED CHANGE button to set the Power Unit speed as required.
• If the POWER button is pressed when the START/STOP switch is in the START position, the POWER
and the ALERT
position and then press the POWER button.
• It may take some time for the indicators to light after the POWER button is pressed. If the indicators do not light, press the
POWER button again.
• If the Power Unit is not operated for about one minute after the POWER button is pressed, the POWER
Press the POWER button again to start the Power Unit.
REMOVING THE BATTERY PACK
Refer to the Machine Description section to identify the components.
CAUTION
ENSURE the machine is switched OFF before removing the battery.
1. Remove the power cable from the Battery Pack.
2. Pull the battery fastener down to unlock, tilt the Battery Pack up and pull the Battery Pack claw out from the battery
hook, and remove the Battery Pack.
3. Attach the battery connector cap to the power cable.
Operating Instructions
23
START/STOP switch to the STOP
GB
Publicidad
