Publicidad
Idiomas disponibles
Idiomas disponibles
GB | Replacement Button
Designed for wireless doorchimes of types P5760, P5763, P5763R.
Specifications
Transmission range: up to 120 m in an open area (can drop down to one fifth
in a busy area)
Button: water resistant; enclosure IP44
Pairing of chime with buttons: self-learning function
Number of ringtones: 16 tunes – up to 8 buttons can be distinguished by
setting different ringtones
Button power supply: 1× 3 V battery (type CR2032)
Includes: double-sided adhesive tape, 2 screws
Button description:
Battery compartment (see Fig. 1)
Front side (see Fig. 2)
A – battery
B – button for changing ringtone/erasing memory of paired buttons
C – ring button/LED
Opening the Rear Compartment of the Button (see Fig. 3)
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver through the
hole on the side, see "Opening the Real Compartment of the Button". Insert
a 3 V battery, type CR2032, into the button. When inserting the battery,
make sure to observe correct polarity (+ polarity up)!
2. Put the chime into self-learning mode based on the type of power supply
of the doorchime a) 230 V or b) 3× 1.5 V AA.
a) Plug the chime into a 230 V AC/50 Hz socket. You will hear a
"ding dong" tone.
b) Insert 3× 1.5 V AA batteries into the battery compartment of the
chime. You will hear a "ding dong" tone.
The chime automatically switches to self-learning mode which lasts for
60 seconds.
3. During these 60 seconds, press the button (C) you want to pair with
the chime. If the chime receives signal from the button, a tone will
sound, the button will pair with the chime and the self-learning mode
will automatically end.
4. For pairing multiple buttons, repeat steps 1 to 3.
3
Publicidad
